Installation problem

kisielrambo · 06-29-2007, 09:48 AM

Hi,
there's RAID1 and I can't install slack 11.0. I've used test26.s and everething was fine. Raid controller & disk were found -

Code:

dmesg :
I2O Block Device OSM v1.325
i2o/hda: i2o/hda1 i2o/hda2 < i2o/hda5 i2o/hda6 >
block-osm: device added (TID: 00d): i2o/hda

Then I've tried to create partitions but there was no /dev/i2o !!??

Later I've connected ATA DISK and install slack on it (kernel 2.6.21 with I2O support). And now is ok, there are devices /dev/i2o/hda1.. . I can create partitions, etc.

But I want install system on array. Why there is no /dev/i2o during the installation ?? Any ideas??

Regards
Kisiel

PDock · 06-30-2007, 06:07 AM

Did you look here: http://i2o.shadowconnect.com/faq.php
Googling i2o was really daunting.

Chances are you will have to issue the mknod commands before fdisk.

kisielrambo · 07-01-2007, 04:08 AM

Thanks PDock, but at first I'll try upgrade SRCU31 to SRCU31A(gdth module support this)