hi ,

i am new to linux and to this forum as well,i may be asking something quite simple
or may be missing something,pls kindly bare me if so.


i tried to assign the range of ip address to eth0.
but its not working.



Following is my configuration:

operating system : RHEL6


#vi /etc/sysconfig/network-scripts/ifcfg-eth0:0

DEVICE="eth0:0"
TYPE="Ethernet"
IPADDR="192.168.1.108"
NETMASK="255.255.255.0"
GETWAY="192.168.1.1"
ONBOOT="yes"
BOOTPROTO="static"
DNS1="192.168.1.104"
NM_CONTROLLED="yes"


#vi /etc/sysconfig/network-scripts/ifcfg-eth0-range0

IPADDR_START="192.168.1.109"
IPADDR_END="192.168.1.129"
CLONENUM_START="2"

#ifconfig -a

eth0 Link encap:Ethernet HWaddr 00:0C:29:57:39:A5
inet addr:192.168.1.108 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::20c:29ff:fe57:39a5/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2334 errors:0 dropped:0 overruns:0 frame:0
TX packets:426 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:194379 (189.8 KiB) TX bytes:34434 (33.6 KiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:321 errors:0 dropped:0 overruns:0 frame:0
TX packets:321 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:37807 (36.9 KiB) TX bytes:37807 (36.9 KiB)

sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)








======================

Do i need to do something else,
i think ifconfig should list all the assigned range of ip address of eth0,

thx in advance

i guess you would need a network service restart

Refer:
http://www.ducea.com/2006/07/15/linu...based-systems/

aleardy done many times

So is the problem resolved or you are still with it?

still there