LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Wireless Networking (http://www.linuxquestions.org/questions/linux-wireless-networking-41/)
-   -   WPA-PSK TKIP Ndiswrapper - No data issue (http://www.linuxquestions.org/questions/linux-wireless-networking-41/wpa-psk-tkip-ndiswrapper-no-data-issue-299865/)

sti2envy 03-09-2005 11:53 PM

WPA-PSK TKIP Ndiswrapper - No data issue
 
I managed to get my my genius gw7200 pci card working with ndiswrapper on winxp drivers. I added WPA-PSK security, enable SSID broadcast on my Linksys WRT54G AP.

[root@toys ~]# iwlist wlan0 scan
wlan0 Scan completed :
Cell 01 - Address: 00:0F:66:XX:XX:XX
ESSID:"blahblah"
Protocol:IEEE 802.11b
Mode:Managed
Frequency:2.457GHz (Channel 10)
Quality:0/100 Signal level:-28 dBm Noise level:-256 dBm
Encryption key:on
Bit Rate:1Mb/s
Bit Rate:2Mb/s
Bit Rate:5.5Mb/s
Bit Rate:11Mb/s
Bit Rate:6Mb/s
Bit Rate:9Mb/s
Bit Rate:12Mb/s
Bit Rate:18Mb/s
Bit Rate:24Mb/s
Bit Rate:36Mb/s
Bit Rate:48Mb/s
Bit Rate:54Mb/s
Extra:bcn_int=100
Extra:atim=0
Extra:wpa_ie=dd160050f20101000050f20201000050f20201000050f20

Output from wpa_cli shows associated with AP:

Selected interface 'wlan0'

Interactive mode

> status
bssid=00:0f:66:XX:XX:XX
ssid=blahblah
pairwise_cipher=TKIP
group_cipher=TKIP
key_mgmt=WPA-PSK
wpa_state=COMPLETED
Supplicant PAE state=AUTHENTICATED
suppPortStatus=Authorized
EAP state=SUCCESS

[root@toys ~]# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:40:F4:XX:XX:XX
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::240:f4ff:fec4:cce9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:528 errors:0 dropped:0 overruns:0 frame:0
TX packets:1235 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:54485 (53.2 KiB) TX bytes:157794 (154.0 KiB)
Memory:dd020000-dd021fff

[root@toys ~]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0
169.254.0.0 * 255.255.0.0 U 0 0 0 wlan0
default 192.168.1.1 0.0.0.0 UG 0 0 0 wlan0

Pinging to WWW has no response at all, can only ping internal IP's. When pinging domains, dns is resolved properly too.

[root@toys ~]# ping woosh.com
PING woosh.com (202.74.207.101) 56(84) bytes of data.

Does anyone has any ideas how to fix this no data issue??


All times are GMT -5. The time now is 09:37 AM.