wlan0 works but not in airsnort?

hotgirl101 · 04-06-2004, 03:06 PM

wlan0 works in kismet and also in ethereal

i can not get it to come up in airsnort i did install an rpm i am going to try to build from source

is anyone else experiencing problem like this

thanks to all who reply

fur · 04-07-2004, 10:19 AM

Is your card even supported by it?

Quote:

AirSnort 0.2.3a Requirements

AirSnort runs under linux, and reqires that your wireless nic be capable of rf monitor mode, and that it pass monitor mode packets up via the PF_PACKET interface. Cards known to do this are:

Cisco Aironet
Prism2 based cards using wlan-ng drivers
Orinoco cards and clones using patched orinoco_cs drivers

hotgirl101 · 04-07-2004, 10:34 AM

wow this has been a crazy ride through pcmcia hell but i have learned a lot

on this problem it was rather simple change the toggle switch to channel rather than scan

hope this post helps others out in the future