Netgear WG311 on Redhat 9
I have a netgear WG311 (athernos chipset) that I am trying to setup on Redhat 9 (Kernel 2.4.20-8). I've installed the wadwifi drivers (I think) and when I scan I am able to find my router. I've been through lots of forums on this topic and tried all the commands I've seen. In the network config, I see the ath_pci bound to eth0, but when I try to activate the connection it says "cannot initialize eth0, it seems the device is not present." Also, after I set the ESSID and nickname and run iwconfig ath0 up (or whatever it is) I'm still unable to get an ip adress using dhconfig and I cannot ping 192.168.0.1. After compliling and installing the drivers I have not created or edited any files.
Last edited by mysterywalrus; 03-03-2004 at 12:56 PM.