-   Linux - Software (
-   -   Write a script to run several commands ??? (

wahaha 04-13-2007 09:02 PM

Write a script to run several commands ???

I am using fedora distribution. There are few commands i have to enter to for a project involved such as below:

# echo 0 > /proc/sys/net/ipv6/conf/eth0/forwarding
# echo 1 > /proc/sys/net/ipv6/conf/eth0/autoconf
# echo 1 > /proc/sys/net/ipv6/conf/eth0/accept_ra
# echo 1 > /proc/sys/net/ipv6/conf/eth0/accept_redirects

May I know is there possible to write a script to run the several commands in terminal if I don't want type the command line by line?

If yes, can you tell me how to do so? Because I have never do so before.

Thank you.

SlowCoder 04-13-2007 09:20 PM

Just copy those lines into a new file, removing the leading #.
then use chmod +x to give it execute permission.

That should be about it.

All times are GMT -5. The time now is 12:00 AM.