Some modules don't get automatically loaded after kernel upgrade
I upgraded redhat 9's kernel from 2.4 to 2.6.16. However my network adapter and sound card are not loaded automatically during system startup (they work properly if I modprobe them manually after the os get loaded). :scratch: I don't know which part is incharge of modules loading (rc.sysinit does some modprobe jobs, but I don't think I should load the network adapter and sound card here). Here is what has been written in my /etc/modules.conf:
alias eth0 via-rhine
alias usb-controller ehci-hcd
alias sound-slot-0 snd-cmipci
post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L >/dev/null 2>&1 || :
pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null 2>&1 || :
alias usb-controller1 usb-uhci
# ALSA portion
alias char-major-116 snd
# OSS/Free portion
alias char-major-14 soundcore
alias sound-service-0-0 snd-mixer-oss
alias sound-service-0-1 snd-seq-oss
alias sound-service-0-3 snd-pcm-oss
alias sound-service-0-8 snd-seq-oss
alias sound-service-0-12 snd-pcm-oss
alias snd-card-0 snd-cmipci
I just don't know what has gone wrong. :confused: Anybody has some ideas?
What was your kernel build steps?
by the way, iptable can not get started as well, i still don't have time to look into this issue...:cry:
You shouldn't use the make install method.
make && make modules_install
Should be used instead. Do you have 2.6 modules in /lib/modules?
For iptables to work in 2.16.16 you need to enable it in the config whether menu config, xconfig, gconfig or whatever. It has changed and even if you use a saved configed file it will not check what is needed. You need to manually do this. So open an old config file and compare the two and modify to match. It is mentioned in the changelog at www.kernel.org. I still think there is one item missing in the 2.16.16 kernel so get the 126.96.36.199 one. Works like a charm after checking the needed items in netfilter section.
I would run make install again. The dependiencies map is not created in the make install command if I remember correctly. You need to do make modules_install before make install
Also with two machines I have being the same I do a ' make rpm ' to make an rpm of the kernel and transfer to the other machine.
|All times are GMT -5. The time now is 03:38 AM.|