LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Software (http://www.linuxquestions.org/questions/linux-software-2/)
-   -   Nagios: check_http from CLI works, but... (http://www.linuxquestions.org/questions/linux-software-2/nagios-check_http-from-cli-works-but-762428/)

cluckinchicken 10-16-2009 02:01 PM

Nagios: check_http from CLI works, but...
 
when Nagios calls it, not so much.

My command from the command line is as follows:

./check_http -H <website> -S -t 15 -w 5 -c 10 -f follow

Result: HTTP OK HTTP/1.1 200 OK - 5124 bytes in 0.690 seconds |time=0.689690s;5.000000;10.000000;0.000000 size=5124B;;;0

When Nagios calls it, it results in a Warning state:

Result: HTTP WARNING: HTTP/1.1 403 Forbidden

Anybody have any ideas?

Thanks ya'alls.
cluckinchicken

carltm 10-16-2009 08:00 PM

Is it possible that you are using different values for <website>?
If you have virtual hosts set up, you might get different results
depending on the hostname that you use.

cluckinchicken 10-19-2009 10:26 AM

I did get it worked out. This was working fine in my v2.11 environment with the commands that I had. Basically I put all my arguments in the commands def, rather than in my service def...except -H <website>. Same command though. Thanks for your reply carltm.


All times are GMT -5. The time now is 09:05 PM.