K3B TDK CDRW241040B Burning Error

Cohobin · 06-28-2004, 01:15 PM

Another day, another question it seems.

I just installed the latest K3b 0.11.12, cdrdao 1.1.9, and cdrecord 2.1a29 packages, and produce this error when I try to burn a Iso image:

Code:

System
-----------------------
K3b Version:0.11.12 
KDE Version: 3.2.3
QT Version: 3.2.3

cdrdao
-----------------------
Cdrdao version 1.1.9 - (C) Andreas Mueller <andreas@daneb.de>
  SCSI interface library - (C) Joerg Schilling
  Paranoia DAE library - (C) Monty
Check http://cdrdao.sourceforge.net/drives.html#dt for current driver tables.
Using libscg version 'schily-0.8'
ERROR: Inquiry command failed on 'ATAPI:/dev/hdc'.
ATAPI:/dev/hdc:   Rev: 
Using driver: Generic SCSI-3/MMC - Version 2.0 (options 0x0010)
Burning entire 79 mins disc.
Starting write ERROR: Cannot retrieve drive capabilities mode page.
at speed 0...
Process can be aborted with QUIT signal (usually CTRL-\).
ERROR: Cannot retrieve write parameters mode page.
ERROR: Cannot setup write parameters for session-at-once mode.
ERROR: Please try to use the 'generic-mmc-raw' driver.
ERROR: Writing failed.

cdrdao comand:
-----------------------
/usr/bin/cdrdao write --device ATAPI:/dev/hdc --driver generic-mmc:0x00000010 --speed 24 -n -v 2 --eject --remote 18 /tmp/kde-cohobin/k3brheJRb.tmp.cue

I googled around for my burner but haven't found anything on it. I am trying to load the generic-mmc-raw driver (by specifying my burner in the /usr/share/cdrdao/drivers file) but that does not work either.

I have the ide-scsi, and ide-cd modules loaded; as most of the other posts say to do to fix problems with k3b.

Any suggestions?

Cohobin · 06-28-2004, 03:10 PM

I should note that I have checked the tables listed on what was mentioned in the error message... that's where I tried to change the drivers file.

Cohobin · 06-28-2004, 03:58 PM

haha, I should note that every time I post on here I figure it out about 7 hours later... dunno what that's all about.

Anyways, burning is working now. I had remove and reinstall the ide-scsi driver for some reason, after that, everything worked fine. Strange, but hey, if it works, it works I guess.