Hello

I would be most grateful if anyone could give me a hint as to where one can enter the DisEqC settings in Kaffeine.

I'm running Kaffeine 0.8.3 under Ubuntu 6.10 with the xine engine.

The DVB-s card is B2C2 FlexCopII DVB chip / Technisat SkyStar2 DVB card
linux.driver: b2c2_flexcop_pci

Under "Configure DVB" in Kaffeine, the card shows up as 1 device:
DVB Device 0:0

I can successfully scan the channels on the first LNB, but where do I tell Kaffeine to use the 4x1 DisEqC 1.0 switch that I have attached?

If I increase the "Number of LNBs" to 2 in the Kaffeine DVB settings, the second sat doesn't access any channels, so it probably doesn't get the right DisEqC commands ...

Dual-booting the same hardware into windows (uggh...) the DVBViewer does access both LNBs, the second one with DisEqC Position B Option A

Many thanks for any help!
Robert