Hi there
I am trying to manage TCG OPAL drive on the DELL PRECISION 490 with 631xESB/632xESB SATA AHCI Controller

This is what I get during boot after I enabled TPM support for ata by specifying "options libata force=noncq allow_tpm=1" in the /etc/modprobe.conf

[ 10.634109] tg3 0000:0b:00.0: eth1: Link is up at 100 Mbps, full duplex
[ 10.634307] tg3 0000:0b:00.0: eth1: Flow control is on for TX and on for RX
[ 10.634307] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[ 21.146010] eth1: no IPv6 routers present
[ 130.016035] ata3.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x6 frozen
[ 130.016725] ata3.00: failed command: TRUSTED RECEIVE
[ 130.017205] ata3.00: cmd 5c/01:04:00:10:00/00:00:00:00:00/00 tag 0 pio 2048 in
[ 130.017206] res 40/00:00:00:01:00/00:00:00:00:00/00 Emask 0x4 (timeout)
[ 130.018603] ata3.00: status: { DRDY }
[ 130.018955] ata3: hard resetting link
[ 130.324024] ata3: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
[ 130.325345] ata3.00: supports DRM functions and may not be fully accessible
[ 130.326828] ata3.00: supports DRM functions and may not be fully accessible
[ 130.327524] ata3.00: configured for UDMA/133
[ 130.327943] ata3: EH complete
[ 793.254812] svc: failed to register lockdv1 RPC service (errno 97).
[ 815.651515] hub 2-0:1.0: state 7 ports 8 chg 0000 evt 0100

Any help is much appreciated

Thanks

Please post your thread once and in only one forum. Posting a single thread in the most relevant forum will make it easier for members to help you and will keep the discussion in one place. This thread is being closed not to inconvenience you but because it is a duplicate of http://www.linuxquestions.org/questi...er-4175424984/. It appears you have failed to read the LQ Rules. I suggest you do so now.