I have an LM Technologies 54Mbps wifi usb adapter.This is because my wireless section on my motherboard does not work.The drivers on the installation disk do not automatically install for linux. Looking at the manual I have to build the device driver. On the page is computer programing formulie that looks like a foreign language. I do not know computer programing. At the bottom of the page it says:-
Install individual driver
If you only need driver of ZD1211 or ZD1211B you can issue:
make ZD1211REV_B=0(0 for ZD1211,1 for ZD1211b)
make ZD1211REV_B=0 install(o for ZD1211,1 for ZD1211B
to install the driver. Issue where?
Then it says:- Build the debugging tool
There are two debugging tools in this package,"apdbg" and "menudbg". Run"make debug" to complete them both. If you do not have ncurse library, you may get some error messages while compiling meudbg. you can ignore it and get apdbg only.
It goes on and on about network interface, configure wireless settings. I am truly lost with the programing fomulie. I am 68yrs young and can pick things up. But slower than when I was 30. Appreiciate what any one can do for me.
I have read many posts on this problem and many seem to know programing from different operating systems. Even they seem to have a problem setting up linux. So I am not in bad company