hi,
i have an application in which i am calling back end(RTLinux) from front End(GPOS).

I am making and opening a fifo in the back hand and writting some data into it.

now the requirement of my application is that after writing data ( say for 50 interrupts ) i want to stop writing the data & send one signal to GPOS to read it. After reading of the fifo is done by GPOS, my backend (RTLinux) should again start writing data to fifo.

but i am nat able to do this.
plz look into the problem and help me.

thanks and regards
Raghav

Please post your thread in only one forum. Posting a single thread in the most relevant forum will make it easier for members to help you and will keep the discussion in one place. This thread is being closed because it is a duplicate.