slackware 10 and nforce
 

Hello all,

When i try to install the nforce chip set driver I get this error message:

ERROR: Unable to load the kernel module 'nvsound.o'. This is most likely
because the kernel module was built using the wrong kernel source
files. Please make sure you have installed the kernel source files
for your kernel; on Red Hat Linux systems, for example, be sure you
have the 'kernel-source' rpm installed. If you know the correct
kernel source files are installed, you may specify the kernel source
path with the '--kernel-source-path' commandline option.

I am using the latest nforce installer from nvidia (NFORCE-Linux-x86-1.0-0283-pkg1.run). Can anyone please tell me what I am/have done wrong?

Also, I am running kernel 2.4.26. If I am to autoload the modules on boot. Which my file do I edit? /etc/modules.conf or /etc/modprobe.conf?

Thanks for any advice.

you have already posted this exact thread 45 mins previous, located :
http://www.linuxquestions.org/questi...hreadid=230410

we do not take kindly of "littering" the boards with double posts, so
refrain from doing it, and wait patiently for an answer ...

also since you did agree to them when you signed up
i think you may want to read the rules again :
http://www.linuxquestions.org/rules.php

sorry! I wasnt sure where I should have posted.

hi there...

after almost 2 years here and 100 posts you don't know where you should post??

sorry, hard to believe.. :jawa:

regards

slackie1000