LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Newbie (http://www.linuxquestions.org/questions/linux-newbie-8/)
-   -   setting Ip address on the target leopard dm368 (http://www.linuxquestions.org/questions/linux-newbie-8/setting-ip-address-on-the-target-leopard-dm368-4175417348/)

ranjana kumari 07-18-2012 04:19 AM

setting Ip address on the target leopard dm368
 
I am using leopard dm368 evaluation board and booting the board with EUCDK through Sd card. i want to set the ip address of the board. i connected the ethernet cable to the target board and from the uboot prompt of the target gave the following commands - setenv ipaddr <ipaddr>

setenv ipaddr <ipaddr>

setenv serverip <serverip>

setenv gatewayip <gateway>

setenv netmask <netmask>

after giving all these command i gave saveenv. then to check if Ip of the target board has been set or not i gave the command ping <targetip> from the host terminal. But host is not able to ping the target. I gave ifconfig command also but its giving message "try ifconfig help"


All times are GMT -5. The time now is 04:56 PM.