thanks for the help ..but i am trying to get it done with the visualizer..
i am a little confused with the outcome..
please go through what i have tried let me know where i have made a mistake..(its a little repetetive but bear with me)
after going through the wiki page on pyviz(http://www.nsnam.org/wiki/index.php/...Known_problems
) i followed the instructions.
i changed the wscript for 2 files and also changed Simulator::Run() to Visualizer::Run() and the files were
1) first.cc (examples/tutorial/)
And when i ran the following commands
"./waf --run examples/tutorial/first --visualize" for first.cc the console printed the message "error Visualizer not declared
"./waf --run src/mesh/examples/mesh --visualize" for mesh.cc the console building successfully (or so i think) and then prints the line innummerable times "No visualization support (no module named pyvizgraph)"
Why is there a differnce in the outputs of the two files even when i have made the same changes..
And what about the visualizer..
Please guide me in this..Thanks for your time