LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Newbie (http://www.linuxquestions.org/questions/linux-newbie-8/)
-   -   Network Card Issue? Dunno? (http://www.linuxquestions.org/questions/linux-newbie-8/network-card-issue-dunno-162631/)

kaz4u2dig 03-26-2004 10:40 AM

Network Card Issue? Dunno?
 
I have a RR Cable connection, Toshiba Modem, Belkin Router, Two XP machines, and a Linux running (Mandrake 9.2 MCI board no onboard etho) at home. The two XP machines are networked fine. My router assigns them ip's similar to 192.168.2.73 and 192.168.2.52. When I plug in the Linux Machine using an network card ( first one i tried was a...LinkSys) when I plugged it in the light blinked once and never again. I started Drake and it walked me through a install of the network card everything seems ok. But the network card was not blinking, I cannot connect to the internet and my router cannot see it and therefore it will not assign it an ip using DHCP. I opened up the drake network and internet dialog window and it says that the card is down and there is no internet connection. I toyed around with it for a couple of days, trying different options and i managed to get the card "up" but when i clicked on the button to setup the internet connection the net card said "down". With my experience with computers I thought maybe linux is not compatible with this network card, so... I tried two other network cards, Kingston with a Realtek chipset and a 3com which I thought would work for sure. I tried the same steps above with these two other cards and the same problem... no internet connections.
please help

something that might help in finding the problem is that when my linux machine boots up it stays on Eth0 and for a couple minutes finally says found Etho9 or something like that =(
:newbie:

jpbarto 03-26-2004 11:03 AM

don't know about through the gui but if you want to try the command line you can:

execute 'cat /proc/pci' to determine the specifics about the NIC's chipset.
Run a search on the web to determine the proper kernel driver
load the appropriate kernel driver with 'modprobe <driver-name-minus-the-.o-extension>'

then run dhcpcd or some other dhcp client to configure your network connection.

hope that helps,
jpbarto


All times are GMT -5. The time now is 10:48 PM.