Assuming your using Ubuntu (from the icon in your post), does it show in the places menu? If I insert a pendrive, it shows on the desktop
but also shows in the places menu as e.g.
8GB Filesystem. You can click it in the places menu and it will open.
If not, please post the output of
dmsg |tail -n 16 as shown below
Code:
fortyfourgalena@desktop-01:~$ dmesg |tail -n 16
[85091.660026] usb 1-9: new high speed USB device using ehci_hcd and address 6
[85091.813225] usb 1-9: configuration #1 chosen from 1 choice
[85091.824531] scsi7 : SCSI emulation for USB Mass Storage devices
[85091.827920] usb-storage: device found at 6
[85091.827923] usb-storage: waiting for device to settle before scanning
[85096.820168] usb-storage: device scan complete
[85096.865638] scsi 7:0:0:0: Direct-Access USB DISK 30X 1.00 PQ: 0 ANSI: 0 CCS
[85096.867953] sd 7:0:0:0: Attached scsi generic sg3 type 0
[85097.321994] sd 7:0:0:0: [sdc] 15695872 512-byte logical blocks: (8.03 GB/7.48 GiB)
[85097.322859] sd 7:0:0:0: [sdc] Write Protect is off
[85097.322863] sd 7:0:0:0: [sdc] Mode Sense: 23 00 00 00
[85097.322866] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[85097.329859] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[85097.329865] sdc: sdc1
[85097.380351] sd 7:0:0:0: [sdc] Assuming drive cache: write through
[85097.380360] sd 7:0:0:0: [sdc] Attached SCSI removable disk
fortyfourgalena@desktop-01:~$
Please place the output between [code] and [/code] when you post the result here on the forum; it will place your result in a code block like mine above.