LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Newbie (https://www.linuxquestions.org/questions/linux-newbie-8/)
-   -   My Linux Mint 11 can't find the WLAN .. (https://www.linuxquestions.org/questions/linux-newbie-8/my-linux-mint-11-cant-find-the-wlan-894961/)

ironman666 08-01-2011 04:49 PM

My Linux Mint 11 can't find the WLAN ..
 
Hi im new, i'm a complete noob, i have had linux for about 3 hours now.
Everything installed just fine, but i have no WIFI.
So, i have googled the internet so hard.
But no luck :(

My problem is.
I installed Linux Mint 11 on my Dell Inspiron 8600
No wifi
I tried to follow this guide (after endless searching)
http://wireless.kernel.org/en/users/..._and_b43legacy

I then found out my card. By typing this in terminal

lspci -vvnn | frep 14e4
Code:

Network Controller [0280]: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller [14e4:4320] (rev 03)
Ok thats good right? then i checked with the supported cards (http://wireless.kernel.org/en/users/..._and_b43legacy), i found 2 list of 4320, both supported, one says "yes" other say "yes (b43legacy)"

good, i continoue to the next step
i type this in terminal
sudo apt-get install b43-fwcutter
Code:

setting up firmware-b43legacy-installer (4.178.10.4-5)
Not supported card here (PCI ID 14e4:4401
14e4:4320)!
Use b43 firmware. This is just for the b43legacy driver.
Aborting.

And this is where i am right now, having no clues to what i should do next. The error code says "Use b43 firmware" But thats what i did!!

corp769 08-01-2011 05:00 PM

Hello,

With that chipset, you need to use the correct firmware with the applicable revision and version, otherwise you will run into problems. Have a look here - http://wiki.debian.org/bcm43xx#b43-b43legacy-squeeze
That should get you on the right track. Remember, you have revision 3; The b43legacy drivers are not for your device. Also, b43-fwcutter doesn't contain the firmware anymore, so make sure you read that page really good.

Cheers,

Josh

ironman666 08-01-2011 05:15 PM

Thank you so much! It appears to be working now :)

corp769 08-01-2011 05:20 PM

Not a problem man.

Josh


All times are GMT -5. The time now is 06:25 PM.