LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Newbie (https://www.linuxquestions.org/questions/linux-newbie-8/)
-   -   Modem misery (https://www.linuxquestions.org/questions/linux-newbie-8/modem-misery-211178/)

mseq1 07-29-2004 04:15 PM

Modem misery
 
Hi,

Tried searching the forums before posting here.

I'm trying to get my Netcomm Mega-i Modem (external) working with RH 8. My kernel version is 2.4.18.

My modem is on Com 1 , however when I try to configure a connection using the GUI configuraiton tool, i get a message that says 'modem not detected.'

I tried running wvdialconf , but no modem was detected again.

I ran the following command : setserial -bg /dev/ttyS* to get a listing of devices attached to my serial ports and RH reports something on Com1.

when I go echo atz > ttyS0 , I can get the modem LEDs to blink..., but thats as far as it goes....

I have an ethernet card installed, which I disabled thinking that there might be a hardware conflict, but to no avail...

When RH is booting, I get a message that says "Unable to load ppp0, error code 8 "......

Really confused....can someone please help???....


Much appreciated,
Marc

PS : Tried the same modem with my Knoppix bootable. Basically the same problem. When I try to select ttyS0 , the message changes from 'unbale to detect modem ' to ...' 'the modem does not respond'....

shengchieh 07-29-2004 05:00 PM

You got my sympathy. I 1 success vs. 2 failure w/ WinModems. I can't help, but
maybe these docs can. Hate these !@#$%^ WinModems.

Maybe someone else can really help you.

Sheng-Chieh

-----

Modem (problems may occur due to WinModem)
http://www.linmodems.org/
http://linmodems.technion.ac.il/Linmodem-howto.html
http://www.linuxant.com/drivers/hcf/index.php (HCF Rockwell chip)
http://axion.physics.ubc.ca/ppp-linux.html (PPP)
http://pcmcia-cs.sourceforge.net/ftp/SUPPORTED.CARDS (PCMCIA)

Dummy-in-Linux 07-30-2004 05:33 AM

Hello Marc,

I had a similar problem with an external modem; I fixed my problem with the right INIT string.

I would say visit Netcomm website, they have enough technical information to help you on the right way

http://www.netcomm.com.au/

With kind regards,

Richard


All times are GMT -5. The time now is 08:42 AM.