Installing new hardware.
I've google'd and searched these forums for 4 days now! God knows I've tried my best to sort it out by myself!
Config as follows:
RH 9
kernel 2.4.20-8
source code and compiler installed
I have a USB ISDN TA connected. At startup, the TA is identified and a driver is registered for the adapter.
dmesg output is as follows:
hiax_st5481: ST5481 USB ISDN driver v0.1.0
usb.c: registered new driver st5481_usb
st541: found adapter VendorId 0483, ProductId 4810, LEDs 2
st5481_setup_usb:
HiSax: Card 1 Protocol EDSS1 Id=st5481_usb0 (0)
HiSax: DSS1 Rev. 1.1.4.1
HiSax: 2 channels added
modules.conf output is as follows:
alias eth0 3c59x
alias sound-slot-0 es1371
alias usb-controller usb-hci
OK, this tells me that the adapter has been detected, right?
I've also done my homework to find out if the adapter is supported under Linux. It is. ( qbik.ch/usb/devices/showdev.php?id=1548 )
My question is: what do I have to do to make it work?
I've been all over the web! isnd4linux; linux-usb.org, linux howtos. Name it and I've probably been there!
All I need is a howto that says: ok, linux rh recognises your adapter. Fine. Now goto lsusb and do this > then goto modules.conf and do that > then run this etc. etc.
Please point me in a direction, even if it's a document on the web somewhere.
I'm so close, I just need to be pointed in the right direction.
Last edited by r%t; 11-27-2003 at 08:05 AM.
|
