drbd configiration error
 

hai friends


I am getting like this error when start drbd service. please help me how to add drbd module in /proc/module. i am getting following error
ERROR: Module drbd does not exist in /proc/modules
Can not load the drbd module.

is it possible to install without heartbeat only for replication purpose or any other way to install
please advise me


i am using centos5

thanks

Well it looks like you need two packages for this to work:

kmod-drbd-xen.x86_64 : drbd kernel module(s)
kmod-drbd.x86_64 : drbd kernel module(s)
kmod-drbd-xen.x86_64 : drbd kernel module(s)
kmod-drbd.x86_64 : drbd kernel module(s)
kmod-drbd-xen.x86_64 : drbd kernel module(s)
drbd.x86_64 : Distributed Redundant Block Device driver for Linux
drbd.x86_64 : Distributed Redundant Block Device driver for Linux


That's a snippet of what I get.
The module you need will be in the kmod package.

So run:

To see what you have installed.

drbd startup error
 

hai thank u for Your replay

Now installed module but when start the service i getting following error
service drbd restart
Restarting all DRBD resources: 0: Failure: (114) Lower device is already claimed. This usually means it is mounted.
Command '/sbin/drbdsetup 0 disk /dev/sda /dev/sda internal --set-defaults --create-device --on-io-error=detach' terminated with exit code 10

please advise me how to solve it
Thank u

mount |grep sda

What is the output?

To say thanks, click the blue thumbs up on the bottom right of the post that has helped you.

drbd error
 

Thank u for your help

When i use this command

mount | grep sda

output is

/dev/sda2 on / type ext3 (rw)
/dev/sda1 on /boot type ext3 (rw)
/dev/sda5 on /home type ext3 (rw)
/dev/sda3 on /var type ext3 (rw)


Any other solutions

drbd error
 

hai

now i start drbd service in both nodes , i am getting following error.

service drbd restart
Restarting all DRBD resources: 0: Failure: (114) Lower device is already claimed. This usually means it is mounted.
Command '/sbin/drbdsetup 0 disk /dev/sda /dev/sda internal --set-defaults --create-device --on-io-error=detach' terminated with exit code 10
.

please advise me , or any other solutions.

thanks

The issue is you are starting this drbd service and you have [or default] it configured to use /dev/sda but /dev/sda is in you mounted as /, /boot/, /home and /var

Check you configuration, try using a disk that is not in use/mounted.

drbd error
 

Thank for your Reply

then i will create one new partition . like /dev/sda7 and put it in drbd.config file. is it correct. or advise me

Thank u

I am sorry I do not know how drbd works. So can't say. I am sure the manual would say.

Hello,

At this link you'll find an easy to follow, step by step guide for setting up and configuring DRBD on CentOS. Compare it to yours, with special attention to the mounted/unmounted state of the partitions ;).

Kind regards,

Eric

drbd error
 

hai

I have one doubt. pleae advise me,

1. Is it possible to install DRBD without clustering?

2. Can support DRBD with SATA Harddisk ? or Possible to SCICI


Thanks
SAran

Actually DRBD doing replication and distribution of the data among the storage system(say like you have physically 2 different storage areas and you are replicate your data within these two storage system). I do not understand your questions what is your intention to install DRDB and why do you ask this with out clustering?

drbd error
 

I am trying to install drbd with two nodes. it contains sata harddisk with both system same configurations.
i am not able start server it shows /dev/sda already mounted .error code is 10.

Please advise me.

Before start the DRBD manually unmount the particular partition (the partition that you are using for replication). if everything fine then comments the entry from fstab permanently (for particular partition)

drbd error
 

Thank u for reply

/dev/sda is fully harddisk device partition inside this lot of sub partition created while installing like this
/dev/sda1 mounted boot
/dev/sda2 mounted in root
/devsda3 for /home

now what can i do
please advise me