Rollover to db9
Hi all
Though i realize that this site is mostly intended for linux questions i am hoping that i can get an answer. I ask using form because i know there are people on this form that can answer my question. I apologize in advance to those of you who feel i should ask this somewhere else.
I have recently gotten a cisco 2515 Router and 1900 switch. These devices are used and i have no information about them so i will need to reset all the functions using a console port connection. It seems that the only way to do this is to use a db9 to rj45 connector or db25 to rj45.
I choose to use the db 9 connector. The problem is i cannot get the pinout correct. here is the diagram i am using.
Signal Console Port (DTE) RJ-45 Rolled Cable Adapter Signal
RJ-45 RJ-45Pin DB-9 Pin
CTS 1 8 7 RTS
DTR 2 7 4 DSR
TxD 3 6 3 RxD
GND 4 5 5 GND
GND 5 4 5 GND
RxD 6 3 2 TxD
DSR 7 2 6 DTR
RTS 8 1 8 CTS
Here is where i think that my bd 9 adapter is not working. the 5 pins seem to need to share some type of connection and i don’t know what i should do. i have left one or the other not connected and that seems to be no good. i have the rollover cables made that was the easy part. I just cannot get this db 9 adapter pinout correct.
Can you please help or steer me to the correct location for help.
thanks
Last edited by rkemp; 12-20-2004 at 12:44 AM.
|