QUAGGA, start zebra daemon problem.
Hi all
I installed Quagga-0.99.5 new version on SUSE 10 linux from tar package.
Installation (./configure, make, make install, add port information to "etc/service") was OK.
When I start zebra daemon mode, there was not any message and log message.
(zebra -d -f /usr/local/etc/zebra.conf)
(zebra -d -A 127.0.0.1 -f /usr/local/etc/zebra.conf)
(zebra -d -A 127.0.0.1 -P 2601 -f /usr/local/etc/zebra.conf)
But, I think the Zebra daemon could not start.
I can not connect to zebra daemon via VTY (telnet localhost 2601). Also after start zebra command, there was not any zebra on memory (I checked "ps -ae")
I am planning: after start zebra, I want to configure OSPFD.
How can I start zebra daemon ?
Last edited by ERBRMN; 10-18-2006 at 05:35 AM.
|