OpenSwan: "%defaultroute" or "can't identify ourselves"
Danged if I do, danged if I don't...
(1) In "ipsec.conf," the config says "interfaces=%defaultroute"
(2) In a connection that says "left=%defaultroute," I get:
"%defaultroute requested but not known"
(3) If instead "left=192.168.254.254" (the default gateway from here):
"cannot identify ourselves with either side of the connection"
Note: If I put left=w.x.y.z, where "w.x.y.z" is the actual IP-address of my ethernet port, into the conn(ection) entry in ipsec.conf, then I can proceed.
But, obviously, I shouldn't have to specify any hard-coded address. There must be another, obvious :rolleyes: way to specify that "the connection is 'from here.'"
Also: "%any" gives the same "can't identify" message as before.
|All times are GMT -5. The time now is 01:58 AM.|