Hi,
i'm running MDK 10 download edition with a Realtek-8029 (AS) ethernet card, and i'm connected to the internet with a arris CM450 touchstone cable modem (ISP = UPC belgium). I can reach anything i want on the internet, but my connexion is very slow (about 4Ko/sec, wich is very deceivefull for a cable) and is getting down to freeze in a few seconds. Than, it restart at +/- 4Ko/sec etc, etc....
Here is my ifconfig
Quote:
[root@cable-62-205-125-70 felix]# ifconfig
eth0 Lien encap:Ethernet HWaddr 00:80:C8D:E5:F4
inet adr:62.205.125.70 Bcast:255.255.255.255 Masque:255.255.252.0
adr inet6: fe80::280:c8ff:fedd:e5f4/64 Scope:Lien
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2899230 errors:0 dropped:0 overruns:0 frame:5978
TX packets:32602 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:203564863 (194.1 Mb) TX bytes:3356682 (3.2 Mb)
Interruption:5 Adresse de base:0xd400
lo Lien encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
adr inet6: ::1/128 Scope:Hôte
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:106 errors:0 dropped:0 overruns:0 frame:0
TX packets:106 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:6626 (6.4 Kb) TX bytes:6626 (6.4 Kb)
|
and here is what dmesg|grep eth shows
Quote:
[root@cable-62-205-125-70 modules]# dmesg|grep eth
eth0: RealTek RTL-8029 found at 0xd400, IRQ 5, 00:80:C8D:E5:F4.
eth0: no IPv6 routers present
eth0: no IPv6 routers present
device eth0 entered promiscuous mode
device eth0 left promiscuous mode
eth0: no IPv6 routers present
eth0: no IPv6 routers present
|
My ISP (who don't know anything about linux) told me about the need of a half_duplex config for the ethernet card, and i add this line 'MEDIA=10BaseT' in the /etc/sysconfig/network-scripts/ifcfg-eth0 file, as i saw on an another thread, but it doesn't help. I've also tried mii-tool, but here is what i get :
Quote:
SIOCGMIIPHY on 'eth0' failed: Operation not supported
no MII interfaces found
|
When i go to the MDK control center "internet acces", it is said that my LAN connexion is not connected.... But i've configure a cable connexion, and i'm connected on this forum... And reconfiguring a new eth0 does not change anything.
I have no firewall, no proxy's, dhcp works, i've the DNS servers...
Can someone give me a push?