Ip Addresses responding on wrong NICs
Hi All,
I hope someone can be of some assistance. I have a standard Suse 9.0 installation (no extras included or removed) with three Network cards. I configured them in Yast and everything went fine. The only problem now is that although I configured each card to have only one IP address, and each card has a unique IP address, one card responds to all the IP's and the other two do not respond at all. i.e. If remove the network cable from eth1 and eth2 and ping the box with the IP addresses of eth0 or eth1 or eth2, I get a response. If I remove the cable from eth0 and plug in eth1 and eth2 and ping the box with the IP address of eth0 or eth1 or eth2 I get no respose. How can this be happenig? I did a standard installation and set up the network cards with Yast, that all I did. I even re-installed Suse but that did not help. Attached is a dump from ifconfig. Any help will be greatly appreciated. Regards, Adrian eth0 Link encap:Ethernet HWaddr 00:02:B3:CB:D8:67 inet addr:192.168.0.25 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::202:b3ff:fecb:d867/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:0 (0.0 b) TX bytes:288 (288.0 b) Interrupt:11 Base address:0xdf00 Memory:feafe000-feafe038 eth1 Link encap:Ethernet HWaddr 00:07:E9:F2:CE:90 inet addr:192.168.0.222 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::207:e9ff:fef2:ce90/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:330 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:64698 (63.1 Kb) TX bytes:288 (288.0 b) Interrupt:11 Base address:0xde80 Memory:feafd000-feafd038 eth2 Link encap:Ethernet HWaddr 00:07:E9:F2:CE:92 inet addr:192.168.0.223 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::207:e9ff:fef2:ce92/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:0 (0.0 b) TX bytes:288 (288.0 b) Interrupt:11 Base address:0xdd80 Memory:feafc000-feafc038 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:44 errors:0 dropped:0 overruns:0 frame:0 TX packets:44 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:2808 (2.7 Kb) TX bytes:2808 (2.7 Kb) |
Please respond to the duplicate thread here
http://www.linuxquestions.org/questi...hreadid=243368 Please don't post the same thread more than once. http://www.linuxquestions.org/rules.php |
All times are GMT -5. The time now is 11:48 AM. |