Fedora core 1 and 3c905b
 

I'm having this problem with my network card on fedora core 1, And I don't know what to do to fix it.

This is a dual boot system with XP and fedora (which was a reformat of RH9 on a second drive) XP and RH9 work (and worked) just fine. But since i reformatted rh9 with fedora my LAN connection is so slow it takes forever to tranfer 700 megs over the lan from it. (i'd say less than 10 percent of the old speeds)

ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:10:5A:62:99:78
inet addr:192.168.1.102 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:11837120 errors:18042 dropped:0 overruns:0 frame:27118
TX packets:11941012 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4288294353 (4089.6 Mb) TX bytes:3750726934 (3576.9 Mb)
Interrupt:11 Base address:0xb400

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:723255 errors:0 dropped:0 overruns:0 frame:0
TX packets:723255 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:969661633 (924.7 Mb) TX bytes:969661633 (924.7 Mb)

dmesg says this during initialization;
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0f.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xb400. Vers LK1.1.18-ac
00:10:5a:62:99:78, IRQ 11
product code 5152 rev 00.12 date 11-07-98
Internal config register is 1000000, transceivers 0xa.
8K byte-wide RAM 5:3 Rx:Tx split, autoselect/10baseT interface.
Enabling bus-master transmits and whole-frame receives.

I havn't noticed messages saying anything about it....

I've been looking around on the internet and all I can find is these cards not working at all with kuzdo on older beta builds of fedora. I really don't know all that much about trying to fix something like this on linux if it 'doesn't just work'... Where should I start looking? Or what should I do? On the hub it's connected to, it shows the 100M light.