Can't get two kingston NICs to work
 

Hi All!

I recompiled kernel 2.4.26 on slack 10 with support (builin support no as a module) for RealTek 8139too because during the boot both eth0 and eth1 are detected with RealTek 8139B chipset. But then, later during the boot, messages say:

Note: /etc/modules.conf is more recent then /lib/modules.2.4.26/modules.dep
modprobe: Can't locate module 8139too

ifconfig command only shows the lo and eth settings.

did anyone have the same problem?

thanks

Hi, I've not encountered this problem, both of my nics work fine. Just the same this may help.

http://www.ibiblio.org/pub/Linux/doc...WTO.html#ss2.4

good luck.