HI I am trying to enable 3d accel on my laptop in suse 9.3 Pro. SAX says that 3d is enabled form my card and seems to detect my card correctly but Tuxracer still gived me the 3d support not enabled error. Here is the output from lspci incase it helps. Any help would be greatly appreciated.

0000:00:00.0 Host bridge: ATI Technologies Inc RS200/RS200M AGP Bridge [IGP 340M] (rev 02)
0000:00:01.0 PCI bridge: ATI Technologies Inc PCI Bridge [IGP 340M]
0000:00:03.0 Modem: ALi Corporation M5457 AC'97 Modem Controller
0000:00:04.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link Controller Audio Device (rev 02)
0000:00:06.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU]
0000:00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV]
0000:00:0a.0 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev aa)
0000:00:0a.1 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev aa)
0000:00:0a.2 FireWire (IEEE 1394): Ricoh Co Ltd R5C552 IEEE 1394 Controller (rev 02)
0000:00:0c.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 50)
0000:00:0c.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 50)
0000:00:0c.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51)
0000:00:0f.0 IDE interface: ALi Corporation M5229 IDE (rev c4)
0000:00:12.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
0000:01:05.0 VGA compatible controller: ATI Technologies Inc Radeon IGP 330M/340M/350M
0000:06:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8180L 802.11b MAC (rev 20)

thanks

mike

While in X, open a terminal window and type glxinfo. What SAX is reporting is probably software rendering enabled via Mesa, but Tuxracer required hardware rendering from the card itself. Post the ouput from the lines near the top about "Direct Rendering" and "GLX vendor".

It took me a long time to get 3d to work on my IGP 320M. I finally did with the dri-common and dri-radeon packages from sourceforge.net.