Quote:
Code:
Loadmodule: NVIDIA |
However, I booted and NVIDIA was well loaded. However when I rebooted in order to be sure that everything is in order, the error reappeared.
I then try to load nvidia-kernel and nvidia-driver using modprobe but it reply coldly, "FATAL: Module not found." |
When i've created an xorg.conf file in the past, it says error, no screen detected; but when used, it still worked. Did it fail or just have errors?
|
It failed and had errors, of course.
|
Reinstalled Slackware using installslackpkg. Then, tried but failed again with the same error.
|
Guess what? Still unsolved.
Again I tried and tried . This time after blacklisting nouveau, creating 20-nvidia-conf, I run nvidia-switch --install and then nvidia-xconfig, creating the following Xorg.conf file: Code:
# nvidia-config: X configuration file generated by nvidia-xconfig Code:
Loadmodule: NVIDIA Quote:
When Linux is loading, if found the following message: Code:
nvidia 0000:00:03.5 failed with error -1 |
Ok. I've installed nvidia and it is working but it didn't change anything, still after some minutes of using, the temperature of the macbook increases and the fans starts. Therefore, this issue is independent from the graphic driver used, nouveau or nvidia.
I dual-boot Slackware64 3.2.29 with Mac OS X on a white Macbook 5.2 from 2009 (http://www.everymac.com/systems/appl...dia-specs.html), using the generic kernel. Even when I am not running X and doing anything, only after some minutes my macbook overheats and the fans start. This issue occurs only with Linux, I never have this on my Mac OS X session. Code:
$ sensors |
Anybody knows?
|
Sorry, out of ideas in this case.
|
All times are GMT -5. The time now is 09:06 PM. |