Malachite

[Log in to get rid of this advertisement]

Greetings all. I have a home built desktop running on an ABIT IT7 Max2 MB.

This MB has the standard IDE controller capable of running 4 devices plus an additional HighPoint 473 ata133 raid controller capable of running 4 more.

Currently there is one 40G IDE drive and a CDROM on the original master/slave and two SATA 150 drives attached to the ata133 highpoint controller. (Weird config that a 133 device has a 150 option and sata ports but it does.)

In the BIOS the two drives are left in the unconfigured state. It only allows a JBOD selection if I select both drives to be JBOD'd together so I skipped that to allow them to be seen by the OS as individual drives. I booted into windows XP just to make sure the overall hardware was sane and everything works well with two 320G sata drives and the one 40G ide.

I Then installed F8 and F9 and the installer keeps seeing the two sata drives as a mpath01 device and trying to make them one single 320G device. Since they are going to be data only I decided to just install to the 40G drive and ignore the 320's for now. This seemed to work fine but after rebooting it basically fails with the following:

Uncompressing Linux... Ok, booting the kernel.
Red Hat nash version 6.0.19 starting
device-mapper: table: 253:0: multipath: error getting device
device-mapper: reload ioctl failed: Invalid argument
device-mapper: table ioctl failed: No such device or address
device-mapper: deps ioctl failed: No such device or address

and then it segfaults.

If I boot into rescue mode everything works fine and I see sda, sdb and sdc perfectly fine. The 320G drives are sda and sdb and the 40G drive with the os is sdc. I can even chroot my disk perfectly fine.

I want to see the individual disks so I am thinking that maybe if i can remove the dm_* components from the initrd file then maybe that will be a good workaround.

My problem is removing the modules to be able to run mkinitrd.

Anyone have any ideas or suggestions?

Malachite

Looks like I found my own answer finally. I will post it here in case someone else runs across this. Reading the man page for mkinitrd didn't give all the solutions. After just typing mkinitrd <enter> I found a new option that appears to be the one I needed. Basically my solution was mkinitrd --omit-dmraid.