TVCARD cx88 i'm half way there on fc3
 

I've been having probs with installing my tv card. I posted elsewhere but even though it was very helpful i had no success. I have realised though after a post i saw today that as well as the bt878 chip my type of card Leadtek TV2000 XP, can also have a cx88 type chip as well.

All this time i was saying i had a bt878 but it was cx88, ithink!!!!!!!!!

So i tried the following and got a picture/ sort of/ just there was a bit of overlapping interference but i think that means i have to experiment with the options. Anyway, all i would like to ask is if someone could tell me how to stop fc3 detecting the wrong card and let it know which card type it is, i added code to the modprobe.conf but that mae no change so i assume an earlier start up script detects or has pre existing info on the card.

When i saw the other post he mentioned it being card=5 tuner=38 so i did

rmmod bt878
rmmod bttv
modprobe bttv pll=1 radio=1 card=5 tuner=38


Opened tvtime and there was a picture with some interference (where before there was no signal at all) so maybe i'm tuner 39 or something, i'll look further for this info)

I added this to modprobe.conf but obviousely that's the wrong place, could someone please help?

Here's the dmesg log info:
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 11, latency: 32, mmio: 0xea022000
bttv0: detected: Leadtek TV 2000 XP [card=34], PCI subsystem ID is 107d:6609
bttv0: using: Leadtek WinFast 2000/ WinFast 2000 XP [card=34,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=003ff502 [init]
bttv0: using tuner=5
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: add subdevice "remote0"


This is the output from xawtv hardware scan

[root@hugoboss ~]# xawtv -hwscan
This is xawtv-3.94, running on Linux/i686 (2.6.11-1.14_FC3)
looking for available devices
port 59-59
type : Xvideo, image scaler
name : ATI Radeon Video Overlay

/dev/video0: OK [ -device /dev/video0 ]
type : v4l2
name : BT878 video (Leadtek WinFast 20
flags: overlay capture tuner

[root@hugoboss ~]#



I'm so close, please help!!!

Regards

Keith