Redhat 9 on Dell Inspiron 5000: Internal Modem is not working
Just installed Redhat on my laptop and all is looking good. I just can't get the internal modem to work.
when I do a cat /proc/pci|more, I get this: __________________________________________________ Communication controller: Lucent Microelectronics WinModem 56k (rev 1). IRQ 5. Master Capable. No bursts. Min Gnt=252.Max Lat=14. Non-prefetchable 32 bit memory at 0xfc000000 [0xfc0000ff]. I/O at 0x1080 [0x1087]. I/O at 0x1800 [0x18ff]. Bus 1, device 0, function 0: --------------------------------------------------------------------------------- but when i run the setserial command I get: --------------------------------------------------------------- [root@nkosi root]# setserial /dev/ttyS0 /dev/ttyS0, UART: 16550A, Port: 0x03f8, IRQ: 4 ---------------------------------------------------------------- From this I can tell the modem is suppossed to use IRQ 5 but the setserial seems to think the internal modem is on IRQ 4 . Also the memory address used by both are not the same.. I have tried the PCMCIA Howto but could not find a way to get it to use IRQ 5. Consequently , when I try dialing out. It says initializing modem and just stays there. Any one have any ideas how I can get this to work? HELP please. Kofi. |
check linux-laptop.net and linmodems.org.
|
Can I sneak a peak at your XF86Config?
I am trying to get 9 installed on my 5000e, though a different machine getting a look at your XF86config settings may steer me in the right direction.
Thanks |
All times are GMT -5. The time now is 05:58 PM. |