Problems after Kernel update

KR-data · 12-04-2004, 06:56 AM

Hi

I updated my Kernel to version 4.6.9 and it seemed to work just as it should....

Until I tried to connect to the internet. I have to networking devices, and my realtec is detected as it should, but my onboard intel gigabit isn't detected in the new Kernel. What can I do to make this work.

I got some graphics problems too, but we can discouss those when the first problem is solved.

Best regards
Rohde

KR-data · 12-04-2004, 07:02 AM

ups 2.6.9

Went a little fast writing... *blushes*

Darin · 12-04-2004, 08:37 AM

please post the results of these run as root:

Code:

ifconfig
lsmod | grep e1
modprobe e1000
(then try this again if modprobe didn't return any errors:)
ifconfig

KR-data · 12-04-2004, 09:33 AM

I presume you wanted the results for my new kerned, so here they are:

ifconfig
eth0 Link encap:Ethernet HWaddr 00:50:8D:F5:24:77
inet addr:10.0.0.1 Bcast:10.0.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3 errors:0 dropped:0 overruns:0 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1662 (1.6 Kb) TX bytes:2798 (2.7 Kb)
Base address:0xa000 Memory:fc000000-fc020000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

lsmod | grep e1
// no results

modprobe e1000
FATAL: Module e1000 not found.

KR-data · 12-04-2004, 09:37 AM

It seems that the e1000 isn't installed, so I found it on intels page, and I'll try if I can figure e1000 out

KR-data · 12-04-2004, 10:26 AM

Ok I finallly got the e1000 module installed, and modprobe e1000 doesn't give any error any more, but the lsmod | grep e1 doesn't give any results, and the ifconfig still doesn't give any information about eth1.

To me it seems everything is set up correctly, any ideas what went wrong?

KR-data · 12-05-2004, 06:32 AM

Ok, don't ask me how, but now the internet works

Next problem.

I got an radeon 9600pro, and I want to be able to use openGL-graphics. I got the fglrx driver installed, and that part seems to work fine, except it seems like my motherboard and the graphics-card wont cooporate the right way.

I had a problem in windows too, because it tried to run in AGP 8x (whith should be supported), but after manually setting it to 4x in the driver settings it worked fine.

I think it is the same problem again, but I'm not sure. Any ideas how to fix that?