Need IDE driver for PowerPC
I need to hook up a harddrive to a PowerPC chip running Linux 2.4.22.
I am still looking to buy the interface hardware. Can anybody recommend a piece of interface hardware that has a Linux driver that will work with the PPC. I have a Silicon Images 680 board, but doesn't seem to work with the driver I have. Thanx |
The 680 board should work just fine if you have the option compiled into the kernel.
|
I am new to creating Linux embedded systems.
For the 680a Board I enabled: 1. Silicon Image Chip Support 2. Enhanced IDE/MFM/RLL disk/cdrom/tape/floppy support 3. PCI IDE Chipset support 4. ATA/IDE/MFM/RLL Support 5. Generic PCI bus-master DMA support 6. MPC8260/8272 CPM Support 7. PCI The behavior is erratic when the board boots. I never see anything I can identify as a hard drive come up. I am doing this with a Metrowerks Target Wizard software. Is there anything that I am missing? Have you actually been successful in getting a harddrive to work off a PowerPC? Thanx |
All times are GMT -5. The time now is 09:44 AM. |