Hai

I use Suse 9.2 and I just discovered that my mouse scroll is not working....I have tried my best..may be I am missing something obvious..See the last line in red...

any help???

Kumar

localhost:~ # /sbin/lsusb
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 003: ID 046d:c016 Logitech, Inc.
Bus 002 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
localhost:~ # /sbin/lspci
0000:00:00.0 Host bridge: Silicon Integrated Systems [SiS] 760/M760 Host (rev 03)
0000:00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SG86C202
0000:00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS963 [MuTIOL Media IO] (rev 25)
0000:00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE]
0000:00:02.6 Modem: Silicon Integrated Systems [SiS] AC'97 Modem Controller (rev a0)
0000:00:02.7 Multimedia audio controller: Silicon Integrated Systems [SiS] Sound Controller (rev a0)
0000:00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
0000:00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
0000:00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
0000:00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900 PCI Fast Ethernet (rev 91)
0000:00:06.0 CardBus bridge: Texas Instruments PCI1410 PC card Cardbus Controller (rev 02)
0000:00:0b.0 Network controller: Broadcom Corporation: Unknown device 4318 (rev02)
0000:00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
0000:00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
0000:00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
0000:00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
0000:01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS] 661FX/M661FX/M661MX/741/M741/760/M760 PCI/AGP

localhost:~ # uname -r
2.6.8-24.18

-defaultBus 002 Device 003: ID 046d:c016 Logitech, Inc.

In your xorg.conf file, at the end of the core pointers sections, just above the monitor section, add a line that reads

Option "ZAxisMapping" "4 5"

And go up a little bit and set the protocol to "imps/2"

Hai

Still not working....

Regards

Kumar