Matrox G550 Dual Head on Suse 10.0
I have recently been trying to enable dual head working on a Suse 10.0 (64 bit) system using a Matrox G550 dual head card. In order to acheive this I edited the 'xorg.conf' file in /etc/X11 and by virtue of including additional sections for devices, monitors and screens and finally updating the 'ServerLayout' section was able activate dual head working. However, only one screen (the leftmost - device[0]) receives a video signal on starting the system. To bring the other screen into life I've found that the following procedure has to be followed:
1. Activate YAST 2. Select Hardware, and then "Graphic Card and Monitor". The window correctly has tabs for each display and and another for alignment. 3. Click 'OK'. A 'Final Steps' popup is now shown. On it click the 'test' button. The second screen is now activated, shows video and mouse correctly moves between screens. Shortly afterwards a window is shown in the middle of each screen to enable refinement of sizes. Each window has a 'save' and 'cancel' button. 4. Click on any of these buttons. If you click 'save' there is a message saying that changes will be activated on reboot. 5. Cancel or click OK out of all windows and you can continue working in dual head mode. However, even if settings are saved at step 4 on reboot dual screen working is enabled but screen 2 (the right hand screen) has no applied video and the above procedure has to be followed every time to restore dual head working. Moving the mouse / windows previous to carrying out the above procedure shows that system beleives 2nd (right) screen is activated. So my question is "How can settings be establisshed such that at boot-up the 2nd screen has video activated?" Attached below is a copy of my xorg.conf file. Any guidance anyone can give me on how to remedy this situation would be much appreciated! # /.../ # SaX generated X11 config file # Created on: 2005-11-09T13:50:25+0000. # # Version: 7.1 # Contact: Marcus Schaefer <sax@suse.de>, 2002 # # Automatically generated by [ISaX] (7.1) # PLEASE DO NOT EDIT THIS FILE! # Section "Files" FontPath "/usr/X11R6/lib/X11/fonts/misc:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/local" FontPath "/usr/X11R6/lib/X11/fonts/75dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/100dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/Type1" FontPath "/usr/X11R6/lib/X11/fonts/URW" FontPath "/usr/X11R6/lib/X11/fonts/Speedo" FontPath "/usr/X11R6/lib/X11/fonts/PEX" FontPath "/usr/X11R6/lib/X11/fonts/cyrillic" FontPath "/usr/X11R6/lib/X11/fonts/latin2/misc:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/latin2/75dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/latin2/100dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/latin2/Type1" FontPath "/usr/X11R6/lib/X11/fonts/latin7/75dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/baekmuk:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/japanese:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/kwintv" FontPath "/usr/X11R6/lib/X11/fonts/truetype" FontPath "/usr/X11R6/lib/X11/fonts/uni:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/CID" FontPath "/usr/X11R6/lib/X11/fonts/ucs/misc:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/ucs/75dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/ucs/100dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/hellas/misc:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/hellas/75dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/hellas/100dpi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/hellas/Type1" FontPath "/usr/X11R6/lib/X11/fonts/misc/sgi:unscaled" FontPath "/usr/X11R6/lib/X11/fonts/xtest" FontPath "/opt/kde3/share/fonts" EndSection Section "ServerFlags" Option "AllowMouseOpenFail" EndSection Section "Module" Load "dbe" Load "type1" Load "freetype" Load "extmod" Load "glx" Load "v4l" Load "dri" EndSection Section "InputDevice" Driver "kbd" Identifier "Keyboard[0]" Option "Protocol" "Standard" Option "XkbLayout" "gb" Option "XkbModel" "pc105" Option "XkbRules" "xfree86" EndSection Section "InputDevice" Driver "mouse" Identifier "Mouse[1]" Option "Buttons" "5" Option "Device" "/dev/input/mice" Option "Name" "ImPS/2 Generic Wheel Mouse" Option "Protocol" "explorerps/2" Option "Vendor" "Sysp" Option "ZAxisMapping" "4 5" EndSection Section "Monitor" DisplaySize 300 230 HorizSync 30-60 Identifier "Monitor[0]" ModelName "AX3817UT LCD-MONITOR" Option "DPMS" VendorName "IIYAMA" VertRefresh 55-76 UseModes "Modes[0]" EndSection Section "Monitor" DisplaySize 300 230 HorizSync 30-60 Identifier "Monitor[1]" ModelName "AX3817UT LCD-MONITOR" Option "DPMS" VendorName "IIYAMA" VertRefresh 55-76 UseModes "Modes[0]" EndSection Section "Modes" Identifier "Modes[0]" Modeline "1024x768" 80.71 1024 1080 1192 1360 768 769 772 802 Modeline "1024x768" 68.55 1024 1080 1184 1344 768 769 772 797 Modeline "800x600" 48.18 800 840 920 1040 600 601 604 626 Modeline "800x600" 40.83 800 832 912 1024 600 601 604 623 Modeline "640x480" 30.25 640 664 728 816 480 481 484 501 Modeline "640x480" 25.55 640 656 720 800 480 481 484 499 EndSection Section "Screen" DefaultDepth 16 SubSection "Display" Depth 15 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 16 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 24 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 32 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 8 Modes "1024x768" "800x600" "640x480" EndSubSection Device "Device[0]" Identifier "Screen[0]" Monitor "Monitor[0]" EndSection Section "Screen" DefaultDepth 16 SubSection "Display" Depth 15 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 16 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 24 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 32 Modes "1024x768" "800x600" "640x480" EndSubSection SubSection "Display" Depth 8 Modes "1024x768" "800x600" "640x480" EndSubSection Device "Device[1]" Identifier "Screen[1]" Monitor "Monitor[1]" EndSection Section "Device" BoardName "G550" BusID "1:0:0" Driver "mga" Identifier "Device[0]" Screen 0 VendorName "Matrox" EndSection Section "Device" BoardName "G550" BusID "1:0:0" Driver "mga" Identifier "Device[1]" Screen 1 VendorName "Matrox" EndSection Section "ServerLayout" Identifier "Layout[all]" InputDevice "Keyboard[0]" "CoreKeyboard" InputDevice "Mouse[1]" "CorePointer" Option "Clone" "off" Option "Xinerama" "on" Screen "Screen[0]" Screen "Screen[1]" Screen "Screen[1]" RightOf "Screen[0]" EndSection Section "DRI" Group "video" Mode 0660 EndSection Section "Extensions" EndSection |
All times are GMT -5. The time now is 03:01 AM. |