LG CD Burner install???
So I just got me a new internal 52/24/52X LG burner (slack 9.0), plugged it in, and it got detected fine as /dev/hdc (the old CDROM was made slave and now is detected as /dev/hdd). It works fine reading, but I cannot configure it to burn CDs. Here's some output:
# sudo cdrecord -scanbus
Cdrecord 2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 J?rg Schilling
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.7'
scsibus1:
1,0,0 100) 'HP ' 'CD-Writer+ 8200f' '1.0A' Removable CD-ROM
1,1,0 101) *
1,2,0 102) *
1,3,0 103) *
1,4,0 104) *
1,5,0 105) *
1,6,0 106) *
1,7,0 107) *
That's my 4X USB external burner it detected, not the new one. When I didn't plug in the USB burner I got this:
# sudo cdrecord -scanbus
2.0 (i686-pc-linux-gnu) Copyright (C) 1995-2002 J?rg Schilling
scsidev '0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.24
cdrecord: No such file or directory. Cannot open '/dev/sg"'. Cannot open SCSI driver.
here's a snippet of dmesg:
hda: Maxtor 32049H2, ATA DISK drive
hdc: HL-DT-ST GCE-8523B, ATAPI CD/DVD-ROM drive
hdd: LG CD-ROM CRD-8522B, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
blk: queue c0388784, I/O limit 4095Mb (mask 0xffffffff)
hda: 40021632 sectors (20491 MB) w/2048KiB Cache, CHS=2491/255/63, UDMA(33)
hdc: ATAPI 52X CD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
hdd: ATAPI 52X CD-ROM drive, 128kB Cache, DMA
But I cannot figure out which device the new burner uses to write. Any suggestions?
TIA
B.
|