Hello. I have been spending a lot of time trying to get my Leadtek PVR2000 card to work. So far I have good picture and sound, but I cannot change channels. It's stuck on one channel. Here's my outputs:
lspci:
Code:
02:09.0 Multimedia video controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder (rev 05)
02:09.2 Multimedia controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder [MPEG Port] (rev 05)
dmesg:
Code:
CORE cx88[0]: subsystem: 107d:6631, board: Leadtek PVR 2000 [card=9,insmod option]
TV tuner 43 at 0x1fe, Radio tuner -1 at 0x1fe
cx88[0]/0: found at 0000:02:09.0, rev: 5, irq: 225, latency: 32, mmio: 0xd3000000
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
cx88[0]/0: registered device radio0
lsmod:
Code:
Module Size Used by
nvidia 4851088 12
cx8800 28300 0
v4l1_compat 11140 1 cx8800
v4l2_common 6528 1 cx8800
cx88xx 58144 1 cx8800
i2c_algo_bit 8328 1 cx88xx
video_buf 18180 2 cx8800,cx88xx
ir_common 8964 1 cx88xx
btcx_risc 4360 2 cx8800,cx88xx
tveeprom 15248 1 cx88xx
i2c_core 17432 3 cx88xx,i2c_algo_bit,tveeprom
videodev 8960 2 cx8800,cx88xx
My module autoload looks like this:
videodev
cx88xx card=9 tuner=43
cx8800
I'm using an AMD64 gentoo kernel 2.6.15-r7. Seems to have the latest v4l stuff as far as I know. Tv card was not autodetected so I had to put it in manually as card 9. Maybe a design change in the card? I have tried stable and now testing version of TVtime. Both work great if I like one channel only. I did set it to scan channels to no avail.
Anyway, I highly appreciate help on this. There is not much help on the net in configuring this card. Thanks for any help you can give.