Irq probe failed

tsimm · 03-22-2004, 04:41 AM

i installed new harddisk to my computer to make backup to it with dd. that didnt succeeded for some reasons. so i restarted and kernel got panic. removed disk and rebooted again. computer boots up fine, but dmesg says:

Code:

hda: ST330013A, ATA DISK drive
blk: queue c03cdfe0, I/O limit 4095Mb (mask 0xffffffff)
hdc: IRQ probe failed (0xfef8)
hdc: IRQ probe failed (0xfef8)
hdc: no response (status = 0x0a), resetting drive
hdc: IRQ probe failed (0xfef8)
hdc: no response (status = 0x0a)
hdd: IRQ probe failed (0xfef8)
hdd: IRQ probe failed (0xfef8)
hdd: no response (status = 0x0a), resetting drive
hdd: IRQ probe failed (0xfef8)
hdd: no response (status = 0x0a)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-disk driver.
hda: host protected area => 1
hda: 58633344 sectors (30020 MB) w/2048KiB Cache, CHS=3649/255/63, UDMA(33)

what i have to do, to remove these irq probe failed messages?

AutOPSY · 03-22-2004, 07:50 AM

You should try to set the controller to a non enhanced mode or non ata from bios.

This I don't know from experience but, it might work.