LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Hardware (http://www.linuxquestions.org/questions/linux-hardware-18/)
-   -   Invalid command : monitor (http://www.linuxquestions.org/questions/linux-hardware-18/invalid-command-monitor-105508/)

tekn0phile 10-18-2003 07:04 AM

Invalid command : monitor
 
Does anyone know how can I enable the monitor function on a Intersil Prism2 802.11 PCMCIA card ?

I've read some docs but I'm a bit lost.
here's some outputs:
Milo:~ # iwpriv eth1
eth1 Available private ioctl :
force_reset (8BE0) : set 0 & get 0
card_reset (8BE1) : set 0 & get 0
set_port3 (8BE2) : set 1 int & get 0
get_port3 (8BE3) : set 0 & get 1 int
set_preamble (8BE4) : set 1 int & get 0
get_preamble (8BE5) : set 0 & get 1 int
set_ibssport (8BE6) : set 1 int & get 0
get_ibssport (8BE7) : set 0 & get 1 int
dump_recs (8BFF) : set 0 & get 0

Milo:~ # iwconfig eth1
eth1 IEEE 802.11-DS ESSID:"Tux" Nickname:"Prism I"
Mode:Managed Frequency:2.442GHz Access Point: 00:06:25:49:C3:D4
Bit Rate:11Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:72/92 Signal level:-39 dBm Noise level:-149 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

I'm using SuSE 8.2 Pro
Thanks


All times are GMT -5. The time now is 11:53 AM.