| Evengard |
04-19-2009 01:09 PM |
Hybrid tuner 1043:4860 Asus Europa2 OEM Philips Semiconductors SAA7134/SAA7135
Help me please I'm completely desesperated...
My system is Debian Sid (2.6.29-1 kernel, and also tried with squeeze 2.6.26-2)
And I have this:
Code:
evengard@TriOp:~$ sudo lspci -vv
...
02:05.0 Multimedia controller: Philips Semiconductors SAA7134/SAA7135HL Video Broadcast Decoder (rev 01)
Subsystem: ASUSTeK Computer Inc. Device 4860
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR+ INTx-
Latency: 32 (21000ns min, 8000ns max)
Interrupt: pin A routed to IRQ 17
Region 0: Memory at fdefe000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [40] Power Management version 1
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Kernel driver in use: saa7134
...
Part of dmesg:
Code:
[ 8.269213] saa7130/34: v4l2 driver version 0.2.14 loaded
[ 8.269298] alloc irq_desc for 17 on cpu 0 node 0
[ 8.269301] alloc kstat_irqs on cpu 0 node 0
[ 8.269312] saa7134 0000:02:05.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 8.269319] saa7134[0]: found at 0000:02:05.0, rev: 1, irq: 17, latency: 32, mmio: 0xfdefe000
[ 8.269327] saa7134[0]: subsystem: 1043:4860, board: Asus Europa2 OEM [card=100,autodetected]
[ 8.269386] saa7134[0]: board init: gpio is 0
[ 8.269396] IRQ 17/saa7134[0]: IRQF_DISABLED is not guaranteed on shared IRQs
[ 8.270646] scsi 0:0:0:2: Direct-Access Generic USB SM Reader 1.02 PQ: 0 ANSI: 0
[ 8.277650] scsi 0:0:0:3: Direct-Access Generic USB MS Reader 1.03 PQ: 0 ANSI: 0
[ 8.282773] sd 0:0:0:0: [sdb] Attached SCSI removable disk
[ 8.287905] sd 0:0:0:1: [sdc] Attached SCSI removable disk
[ 8.290166] usbcore: registered new interface driver snd-usb-audio
[ 8.292769] sd 0:0:0:2: [sdd] Attached SCSI removable disk
[ 8.297882] sd 0:0:0:3: [sde] Attached SCSI removable disk
[ 8.420845] saa7134[0]: i2c eeprom 00: 43 10 60 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
[ 8.420860] saa7134[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff
[ 8.420873] saa7134[0]: i2c eeprom 20: 01 40 01 03 03 02 03 04 08 ff 00 4c ff ff ff ff
[ 8.420886] saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420898] saa7134[0]: i2c eeprom 40: ff 1d 00 c2 86 10 01 01 0d 01 ff ff ff ff ff ff
[ 8.420910] saa7134[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420922] saa7134[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420934] saa7134[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420947] saa7134[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420959] saa7134[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420971] saa7134[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420983] saa7134[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.420995] saa7134[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.421007] saa7134[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.421020] saa7134[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.421032] saa7134[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[ 8.473272] saa7134[0]: registered device video1 [v4l2]
[ 8.473305] saa7134[0]: registered device vbi0
[ 8.473336] saa7134[0]: registered device radio0
[ 8.473369] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 8.473425] HDA Intel 0000:00:1b.0: setting latency timer to 64
[ 8.670130] dvb_init() allocating 1 frontend
[ 8.985815] hda_codec: Unknown model for ALC883, trying auto-probe from BIOS...
[ 9.196419] tuner-simple 1-0061: creating new instance
[ 9.196424] tuner-simple 1-0061: type set to 63 (Philips FMD1216ME MK3 Hybrid Tuner)
[ 9.196430] DVB: registering new adapter (saa7134[0])
[ 9.196436] DVB: registering adapter 0 frontend -858993460 (Philips TDA10046H DVB-T)...
[ 9.244011] tda1004x: setting up plls for 53MHz sampling clock
[ 10.143296] Adding 7960168k swap on /dev/sda5. Priority:-1 extents:1 across:7960168k
[ 10.492891] EXT3 FS on sda1, internal journal
[ 11.185438] loop: module loaded
[ 11.468010] tda1004x: timeout waiting for DSP ready
[ 11.508510] tda1004x: found firmware revision 0 -- invalid
[ 11.508514] tda1004x: trying to boot from eeprom
[ 13.036624] e100: eth0 NIC Link is Up 100 Mbps Full Duplex
[ 13.836508] tda1004x: timeout waiting for DSP ready
[ 13.876009] tda1004x: found firmware revision 0 -- invalid
[ 13.876012] tda1004x: waiting for firmware upload...
[ 13.876017] saa7134 0000:02:05.0: firmware: requesting dvb-fe-tda10046.fw
[ 13.917934] saa7134 0000:02:05.0: firmware: requesting dvb-fe-tda10045.fw
[ 13.925884] tda1004x: no firmware upload (timeout or file not found?)
[ 13.925938] tda1004x: firmware upload failed
Also tried by using this script to search the right tuner:
Code:
#!/bin/sh
MAXTUNER=100
i=0
while [ $i -lt $MAXTUNER ];
do
sudo modprobe -r tuner
sudo modprobe -r saa7134_dvb
sudo modprobe -r saa7134
sudo modprobe -v saa7134 card=100 tuner=$i
echo "Текущий тюнер:" $i
sleep 2
v4l-info /dev/video1 | head -n 9
scantv -c /dev/video1 -C /dev/vbi0 -n SECAM -f russia
echo
echo "Берем следующую карту"
echo
i=$(($i+1))
done
But without success, it never gave me valid channel...
All that I wan't from this hybrid FM/DVB-T/Analog card is to catch the Analog and FM... I don't need any DVB-T functionality (it isn't available in my country) just the analog channels... But I get just some grey image from the card when tried to open it with mplayer and it just don't want to tune... Please help me!!! |
