FC2 and sata_via
 

Hi,

I instal FC2 with kernel 2.6.5-1.358smp to IDE disk and i have on board sata_via raid too and I take to this disk 2 sata disk with striping and active RAID bus controller: VIA Technologies, Inc. VIA VT6420 SATA RAID Controller (rev 80)
in BIOS and FC2 find this hardware .and instal driver sata_via.ko and when I use fdisk -l I don see any disk I see only hda disk.What driver must be next load to use VIA RAID ? And I see to /var/log/meseges and there is write is find hardware .>

May 26 18:20:44 shotzone-sitel kernel: ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
May 26 18:20:44 shotzone-sitel kernel: VIA8237SATA: IDE controller at PCI slot 0000:00:0f.0
May 26 18:20:44 shotzone-sitel kernel: VIA8237SATA: chipset revision 128
May 26 18:20:44 shotzone-sitel kernel: VIA8237SATA: 100%% native mode on irq 161
May 26 18:20:44 shotzone-sitel kernel: ide2: BM-DMA at 0xd000-0xd007, BIOS settings: hde:pio, hdf:pio
May 26 18:20:44 shotzone-sitel kernel: ide3: BM-DMA at 0xd008-0xd00f, BIOS settings: hdg:pio, hdh:pio
May 26 18:20:44 shotzone-sitel kernel: VP_IDE: IDE controller at PCI slot 0000:00:0f.1
May 26 18:20:44 shotzone-sitel kernel: VP_IDE: chipset revision 6
May 26 18:20:44 shotzone-sitel kernel: VP_IDE: not 100%% native mode: will probe irqs later
May 26 18:20:44 shotzone-sitel kernel: VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
May 26 18:20:44 shotzone-sitel kernel: ide0: BM-DMA at 0xd800-0xd807, BIOS settings: hda:DMA, hdb:pio

And lsmod write :

Module Size Used by
vfat 14976 0
fat 38176 1 vfat
ipv6 214624 14
parport_pc 23616 1
lp 12300 0
parport 34632 2 parport_pc,lp
autofs4 15488 0
sunrpc 110280 1
tg3 69124 0
floppy 52336 0
sg 32288 0
libata 33536 0 [permanent]
scsi_mod 97224 2 sg,libata
dm_mod 37536 0
ext3 108136 3
jbd 50328 1 ext3



Thanks for help
sorry for my bed english

lokop

pls help

:confused:

I have some problem