Debian Etch and PowerEdge T110 module required

carg0 · 03-16-2010, 06:57 AM

Is it possible to use modules from Debian Lenny version into Debian Etch version. I'm able to install Lenny on a Dell Power Edge T110 but when I want to install Debian Etch on the same machine I always get the message "No common CD-ROM drive was detected. The system was able to start up with the CD and begin the installation but stop at this message. I think the problem comes from the SATA controller Intel Corporation Ibex Peak. Is there a way to use the Lenny modules into Etch.

Thank You !

acid_kewpie · 03-17-2010, 02:21 AM

Please post your thread in only one forum. Posting a single thread in the most relevant forum will make it easier for members to help you and will keep the discussion in one place. This thread is being closed because it is a duplicate.