Broadcom BCM4312 Driver installed via Ndiswrapper, but wireless still not showing up.

Crack Kid · 08-07-2008, 10:15 PM

I installed the Driver according to this tutorial, however when I attempt to use kwifimanager to connect, it claims all networks are "out of range", when I can readily connect to a network under windows. When I try "ifconfig wlan0 up", it spits out "SIOCSIFFLAGS: No such file or directory".

Output from iwconfig:

Code:

lo        no wireless extensions.

eth0      no wireless extensions.

wmaster0  no wireless extensions.

wlan0     IEEE 802.11g  ESSID:""
          Mode:Managed  Channel:0  Access Point: Not-Associated
          Tx-Power=0 dBm
          Retry min limit:7   RTS thr:off   Fragment thr=2346 B
          Encryption key:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

If there's any more info y'all need, please tell me.

onebuck · 08-07-2008, 11:03 PM

Hi,

You are using Slackware as your distribution? What version?

What's your hardware? Which kernel?

You should look at the next two links;