I can't, for however much I try, seem to get this card to work. When I go to YAST and Hardware Information the card shows up, but I cannot select a tuner.

Has anyone else tried and successfully gotten this card to work? I've tried searching for help but I am about to give up. Please help.

Here is my dmesg output:

saa7133[0]: board init: gpio is 0
saa7133[0]: dsp access wait timeout [bit=WRR]
saa7133[0]: dsp access wait timeout [bit=WRR]
saa7133[0]: i2c eeprom 00: 43 10 45 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[0]: i2c eeprom 10: 00 ff e2 0f ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 04 08 ff 00 89 ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7130/34: v4l2 driver version 0.2.12 loaded
saa7133[0]: found at 0000:00:0a.0, rev: 240, irq: 9, latency: 32, mmio: 0xed105000
saa7133[0]: subsystem: 1043:4845, board: ASUS TV-FM 7134 [card=16,insmod option]
saa7133[0]: board init: gpio is 0
saa7133[0]: dsp access wait timeout [bit=WRR]
saa7133[0]: dsp access wait timeout [bit=WRR]
saa7133[0]: i2c eeprom 00: 43 10 45 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[0]: i2c eeprom 10: 00 ff e2 0f ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 04 08 ff 00 89 ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]: registered device radio0

I still can't get to tune a channel. And nothing shows up in YAST. The following was accomplished by entering:

modprobe saa7134 card=16 tuner=2 at the command prompt.

my lspci reports this:

linux:/ # lspci
0000:00:00.0 Host bridge: Silicon Integrated Systems [SiS] 741/741GX/M741 Host (rev 03)
0000:00:01.0 PCI bridge: Silicon Integrated Systems [SiS]: Unknown device 0003
0000:00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS964 [MuTIOL Media IO] (rev 36)
0000:00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev01)
0000:00:02.7 Multimedia audio controller: Silicon Integrated Systems [SiS] Sound Controller (rev a0)
0000:00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
0000:00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
0000:00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
0000:00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
0000:00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900 PCI Fast Ethernet (rev 90)
0000:00:05.0 IDE interface: Silicon Integrated Systems [SiS] RAID bus controller 180 SATA/PATA [SiS] (rev 01)
0000:00:0a.0 Multimedia controller: Philips Semiconductors SAA713X Audio+video broadcast decoder (rev f0)
0000:01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS] 661FX/M661FX/M661MX/741/M741/760/M760 PCI/AGP


Please please help!

This page says you should be using card=17 in the line, try that and see how it works.