I'm trying to accomplish a connection between my slackware installation and my barcode scanner (MS9535 Voyager).
The manual says that when i want to connect to a bluetooth device, i have to read the address (MAC) and create a barcode of that address... so far so good.
I've i plugin my bluetooth usb receiver, my kernel recognizes it.
The next thing i do is (00:00:00:00:00:00 isn't my real address
)
Code:
root@1:~# hcitool scan
Scanning ...
00:00:00:00:00:00 VoyagerBT 5607410272
root@1:~# hcitool cc 00:00:00:00:00:00
root@1:~# hcitool con
Connections:
< ACL 00:00:00:00:00:00 handle 42 state 1 lm MASTER
I type the second command immediately when the first command is finished. If i wait for like 10 seconds after i check the connection, i got the following output:
Code:
root@1:~# hcitool con
Connections:
So my scanner isn't connected to my pc.
But the strange thing is that 'sometimes' i got some output from my hcitool
Code:
root@1:~# hcitool con
Connections:
> ACL 00:00:00:00:00:00 handle 42 state 1 lm MASTER
root@1:~# hcitool con
Connections:
root@1:~# hcitool con
Connections:
root@1:~# hcitool con
Connections:
root@1:~# hcitool con
Connections:
...SNIP...
Connections:
root@1:~# hcitool con
Connections:
root@1:~# hcitool con
Connections:
root@1:~# hcitool con
Connections:
root@1:~# hcitool con
Connections:
> ACL 00:00:00:00:00:00 handle 0 state 5 lm SLAVE
root@1:~# hcitool con
Connections:
In my logs i can't find anything about it.