starting sequence

c0c0deuz · 05-31-2002, 02:52 PM

When i start my RH7,3 on my toshiba laptop,
it fails eth0 than it start pcmcia... i guess it should be the opposite? is there a way to change that?
Since i installed RH7.3 it works but i have that fail any way because of the service booting sequence.
thanks
dan

TX_metalhead · 05-31-2002, 05:19 PM

do you connect it to a network? its looking for your ethernet connection(eth0 is your ethernet card) You have to disable it from start-up. Go to your kde kontrol panel and select network setup, and you should see your ethernet card(eth0) go to edit and turn it off.

DavidPhillips · 06-01-2002, 05:12 AM

you should probably start it manually because it may not be connected when you boot all the time.

the file /etc/sysconfig/network-scripts/ifcfg-eth0 will contain the line that tells it to use it on boot.

also if you do want it to load last then put the commands to start it in /etc/rc.d/rc.local