Debian Etch and PowerEdge T110 module required
Is it possible to use modules from Debian Lenny version into Debian Etch version. I'm able to install Lenny on a Dell Power Edge T110 but when I want to install Debian Etch on the same machine I always get the message "No common CD-ROM drive was detected. The system was able to start up with the CD and begin the installation but stop at this message. I think the problem comes from the SATA controller Intel Corporation Ibex Peak. Is there a way to use the Lenny modules into Etch.
Thank You !
Last edited by carg0; 03-16-2010 at 07:54 AM.